全自动封边机对工作场地有哪些要求?-ag捕鱼平台

当前位置:捕鱼游戏主页 > 新闻资讯 >
product center
捕鱼娱乐平台的产品中心
联系捕鱼娱乐平台

济南骏捷数控设备有限公司

销售总机:师楠 18866899200

固定电话:0531—69989273

销售一部:师经理 13001727679

销售二部:谢经理 18766192210

地址:山东省济南市天桥区桑梓店镇绕城高速北200米海风产业园713号

新闻资讯
全自动封边机对工作场地有哪些要求?
发布时间:2015-05-15 09:23:52     浏览次数:1424次

全自动封边机http://www.jndongjun.com/的出现大大方便了操作工人的工作,提高了工作效率,使我们的工作更加方便快捷,全自动封边机并不是在任何场地条件下都可以工作的,下面小编就为大家介绍一下全自动封边机工作的场地要求。
   
1、凡使用有毒的、刺激性的以及易燃物质的工艺过程应放在单独的厂房中,或安排在厂房内专门隔出的地段上,并配备个人防护用品和消防器材。
where the use of toxic, irritant and process technology flammable substances should be placed in a separate plant, or arrange special compartment on the plant out of the area, and are equipped with personal protective equipment and fire-fighting equipment.
   
2、全自动封边机车间里运送原木、锯材、废料的通道应设且消除穿堂风的设施如走廊、门厅、门帘、帘幕等以及防止火灾蔓延的设施如自动防火门、防火防烟挡板、水幕等。
automatic edge banding machine shop in transporting logs, sawn timber, scrap the channel should be set up and eliminate drafts of facilities such as corridors, lobby, curtain, curtains, etc., and to prevent the spread of fire facilities

such as automatic fire doors, fire and smoke baffles, water curtain and so on.
   
3、全自动封边机在车间内需要安全地到达设备上方的工作岗位时,应安装带防护栏杆和楼梯的天桥。厂房地面和天桥通道应敷设防滑地面。
when automatic edge banding machine needs to work safely reach the top of the device in the workshop, the bridge should be installed with a protective railing and stairs. factory floor and non-slip floor should be laid overpass passage.
   
4、全自动封边机常用的人行通道上不应有设备和什线.其宽度不小于1m。
automatic edge banding machine used on walkways people should not have equipment and even lines whose width is not less than 1m.
   
5、全自动封边机http://www.jndongjun.com/地面以下的传送带要用盖板或姗格状防护板齐地盖上,金属板表面应防滑。栅格防护的缝隙宽度不超过30mm,锯末和废料贮槽应安放在厂房外。
automatic edge banding machine belt use below ground cover or shan qi trellis covered with protective sheeting, metal plates should be non-slip surface. raster protection gap width not exceeding 30mm, sawdust and scrap tanks should be placed outside the plant.